Connect the air pump to air stone or filter via air pipe.
Plug into 220-240 volt power point.
To prolong pump life, replace air stones regularly.
Never allow pump to come in contact with water.
Air pumps have to be kept at a height higher than the highest water level of the aquarium, to ensure that the water does not flow back into the air pump in case of electricity failure, and not touching or abutting the aquarium to ensure that the vibration caused by the air pumps does not disturb the aquatic fishes.
Important Safeguard :
Disconnect all the plugs of the electrical aquarium appliances before putting hands into the water.
We recommended that air pump and other electrical aquarium devices, should be connected to correct voltage and power supplies with ground fault circuit interrupters.
Feed 2 to 3 times daily with the amount the fish can consume in 5 minutes. Remove unconsumed food within 30 minutes. Do not over feed as it will lead to cloudy water and may promote and encourage development of harmful ammonia and other infections.
White Fish Meal, Krill and Shrimp Meal, Seaweed Meal, Spirulina, Omega 3 & 6 HUFA, Fish Liver Oil, Brewer’s Dried Yeast, Rich Amino Acids, Vitamin A, D, E, Riboflavin, Niacin, B6, B12, Biotin, Stabilized Vitamin C and Minerals (Ca, Cl, K, Na, P.Mg, ZN, MN, Cu, Se)j, Beta-Carotene, Astaxanthin, Cantaxanthin, Phycocynin, Xanthophy.
Classic Substrate (White) is a white base aqua substrate enriched with nutrients & Minerals. Do not wash it before use. 10 kgs. of substrate will be required to set up a 60 lts. Aquarium of size 24″ x 12″ x 15″ (Length x Breadth x Height).
It is to be used as a layer on the bottom of the aquarium. Classic substrate is meant to be used only for fresh water planted aquariums and fishes. It is not meant for Marine aquatic plants or fishes. It is recommended for fishes that thrive in low pH level.
It is recommended that power filter or canister filters be used where the aquarium used this substrate. Always set the out flow pipe of filter in a position that does not obstruct or hit the substrate directly.
Keep it in a Dark and Cool Place. or Keep Away From Children.
Canister filters are ideal filtration system for an aquarium. Though expensive, they maintain near ideal aquatic environment with little or no outside effort.
You need not carry out regular changes post installing external canister filter.
It is equipped to carry out Chemical, Physical and Biological filtration.
Ideal for 350-400 liter aquarium.
In addition this Canister filter has UV tube, which kills harmful bacteria and other pathogens, thus providing for extra protection for aquatic life.
Installation / User Guide:
According to the diagrammatic representation provided with the product, the buckle (1) and (2) should be unfolded at first, which will separate the main body and barrel-head.
Put the draining skeps with filter medium into the main body and turn, pressing the barrel-head. Then fasten the buckle (1) and (2).
Pull the securing buckle to take out the input and output discreteness. After this, the input and output pipes should be installed and they have to be fastened by nuts. Later, put the input and output discreteness to the former place and press the securing buckle to fix the input and output discreteness.
According to the diagrammatic representation, install the input and out curvy bar in the aquarium. (Notice! the curvy bar with spray bar is output curvy bar, and the curvy bar with dirtiness entrance is input curvy bar.)
According to the diagrammatic representation, press the blue buckle forcibly and leave it immediately. The blue buckle will rebound. and the input bar absorb water into main body at the same time which compel the air out of main body through output bar. When the level of water in output bar is equal to the level of aquarium, you may electrify the equipment to make it work.
Things under the transparent cover are control switch of UV light and indicator light of electricity. (Please bear in mind that life of UV light tube may vary due to various factors and may even seem fine, but it doesn’t mean the UV light is working or functional, when the equipment is working. So it is necessary to check the UV light regularly.)
The Method of Replacing the UV Light Tube :
According to the diagrammatic representation, you should loose the six bolts to separate the barrel-head and the cassette mechanism.
According to the diagrammatic representation, separating the contact of electric wire.